Araldite ARA-400012 Instant Syringe Epoxy, 24 ml, Packaging May Vary

Fool proof

Useful for sticking things that need some flexibility in use.Either mix a small amount of resin by hand using the supplied tool or for the mixer if you are using a larger amount.Simple to use and effective is used appropriately.

Very hard to push from applicator, you need two strong hands. You will have around 2 mins before the glue gets too hard to push. Two extractors included.

The job was quite straightforward but the dispensing process was poorly devised. I will not purchase this particular design of package. The product normally sets very hard after proper mixing, I can only assume that an incorrect mix was dispensed as it took a considerable time to cure.

I used it to stick nylon and wood to acrylic and it bonds very well provided both surfaces are roughened up and the glue is put on each part. It sets quickly and very securely. However the applicator plunger needs so much pressure to combine the two parts of the glue and push it through the nozzle that placing the glue accurately is difficult. The kit comes with two nozzles but they can only be used once because after use they're full of glue and can't be cleaned out. After I'd finished I stood the applicator upright on its plunger and came back later to find one of the tubes had leaked it's contents onto a worktop so ended up throwing the remainder away only half used. As a glue it works very well but the delivery system is pretty useless which overall makes it poor value for the price.

don't bother with the mixing nozzles. just put what you need on a piece of card and mix in little amounts. sets quick and does a great job.

I'll start by saying that I'm a great fan of Araldite. I use Araldite Standard all the time manufacturing radio equipment. I got this syringe dispensed Araldite Instant because I wanted a shortcut in the manufacturing process to eliminate an overnight wait. I thought the double syringe dispenser would allow me to dispense small amounts accurately with minimal waste. Other reviews have complained about the syringe thing but I didn't really believe it could be so unsatisfactory to use. Its impossible to dispense small amounts because the two barrels just do their own thing, one over dispenses, the other takes ages before it begins to dispense at all. You waste a lot of material trying to get a short length where both beads are similar enough to risk using. The glue itself is very stiff and stringy compared to Araldite Standard. It is hard to mix evenly and very difficult to handle and it doesn't flow well. Its unreliable in its setting time, sometimes it sort of cures, sometimes it just remains soft and rubbery for hours until I cut it off and used Araldite Standard. I'd rather wait overnight completely confident in a good and reliable bond than to take a chance on the instant curing properly. I just don't trust it enough to use it on anything going out to a customer. I expected to like it, I wish I could like it but its a pain to use, unreliable and I can't recommend it.

This is the best adhesive, bar none. There really is nothing that comes anywhere close to it. I’ve been using it since the 80’s and I’ve not found anything anywhere near as good.I use it mainly to glue 3D printed parts and the glue joint is usually the strongest part.It’s super convenient to use with the dual syringe setup, just squeeze, mix and apply. After 10 minutes or so there’s no turning back - the joint is permanent.Overall I can’t say enough good about this glue. There really isn’t anything that can compete with it.