GINTOOYUNUSB 3.0 Header Extension Cable,USB 3.0 19/20 Pin Male to Female Internal Extension Adapter(5.9 inch)

These cables saved my bacon. Not because my cables aren't long enough on the contrary there a foot longer then I need. No...... Where they saved me is that cause my case has a recessed motherboard tray to the cases back wall and the motherboard I bought has the 90 degree plugs meant that my cases front panel plugs were to thick to plug in. With these extensions having a female end that's super tiny and minimalistic I was able to plug the extension in and then use my plugs again and so too my front panel USB ports again. :-)

I have a new MSI X870E Tomahawk motherboard and the USB 3.0 header pins were too fat to accept the USB cable from my case. I purchased this extension in the hopes that the connector will fit the motherboard's USB header. It was a tight fit, but it worked.

Some case and motherboard design combos put a great deal of stress on where you plug in, this has a small profile and is flexible enough to make the connection easy and mitigate potential damage in what was an almost impossible situation before.

Worked great for my problem motherboard in my particular situation. The cable does feel a little on the cheap side, but hey, you aren't paying a arm and a leg. I've been using it for quite some time now and zero issues. Would recommend and would buy again.

Worked perfectly to allow me to connect case header to motherboard with a very awkward placement of the header under the graphics card.

I got this header extension because I wanted to throw a better video card in my old EliteDesk 800 G1 Tower from HP. I also had to get an adapter (also on Amazon) to allow for an aftermarket power supply. The USB 3 header on my mainboard was right in-line with where my (long) graphics card would sit in the case and the default USB header stuck up way too high. This header was able to flex just enough that it fit under the graphics card perfectly. It definitely saved the day.

Worked great. Needed it to fit a 6600xt gpu in a optiplex 9020 build.

The product worked perfectly other than not having a clip. It went perfectly flat under the installed fans on the bottom of the board and routed towards the back to connect on the case usb3 cable. The issue is i was just moving things around managing the cables and it was just off. I'll make it work with some electrical tape but it shouldn't be the way.Ok nvm it disconnected from the board side the same way on the other end when I thought it was secure. Might be returning this. Hopefully there are better options.