⚡ Power up your Miele motor like new—don’t let worn brushes slow you down!
OTOTEC’s 2 pairs of carbon brushes (30x11x6mm) with compression springs and U-connection brackets are precision-engineered replacements compatible with Miele S200, S300 (Tango), and S500 series vacuum cleaner motors. Designed to restore motor efficiency and fix intermittent running issues, these durable brushes ensure your vacuum performs at its best without expensive repairs.
| Brand | OTOTEC |
| Product Dimensions | 3 x 1.1 x 0.6 cm; 50 g |
| Item Weight | 50 g |
T**Y
Correct brushes but you have to swap them into the existing holders.
Everything stated by reviewer 'Woody' is correct. They are the correct brushes but they have to be fitted into the existing brass holders, which involves a bit of soldering.Carefully cut the brass clips off the ends of the new brush leads, retaining as much copper lead as possible and remove the new springs, which are a different diameter. Gently prise up the tabs at the end of the existing brass holders, cut the old wires tight to the tabs and remove the old brushes. Fit the new brushes into the holders, passing the copper wire through the centre of the old springs and solder to the undersides of the tabs. When cool, carefully bend the tabs back into place and then refit the assemblies into the motor casing, seating the brushes onto the commutator as well as possible. They will soon bed in.
S**N
The correct brush but wrong spring
The springs are too narrow. It is necessary to cut the wire and use the spring from the old brush or it will escape from the brush holder
O**R
Used as a brush replacement for Miele C3 vaccuum cleaner
The brushes on my vacuum cleaner wore-out.I bought these to replace them. As you cannot buy a brush cartridge from Miele, you have to solder the back plate into the brush carrier.It took a few hours of running to bed in but all going well now!
W**Y
These ARE the correct size BRUSHES for a Miele Vacuum motor
I know this sounds terribly nerdy - because, let's face it, not a lot of buyers will extract the motor from their Miele vacuum, open it up, and replace the carbon brushes.Despite a previous 1 star review, these are the correct size brushes, but they are just the brushes, NOT the brush holder. Brush holder with brushes already installed, is this part - https://www.amazon.co.uk/Miele-Original-Motor-Carbon-Brushes/dp/B00QX1QA2M (Part M32) which is almost impossible to obtain as a complete unit.You therefore have to take the old brushes out of the brass holder and install these. I removed both the spring and end clip from these brushes (as there is a spring already inside the old holder) and just soldered the copper brush lead to the end tab of the end tab of the holder (after cutting the lead for the old brush).
C**R
They fit a Miele C3, but you need to adapt them
You need to do a bit of diy and soldering to fit the bushes to the original housing, but they are the right size for my Miele C3
Trustpilot
2 days ago
1 month ago
