Adafruit 9-DOF Absolute Orientation IMU Fusion Breakout - BNO055

If you are building a drone, flight computer, AHRS, or other project that requires accurate Eular or quaternion vectors, skip all the googling for equations and put this thing in "fusion mode" (see bno055 data sheet). The on board mcu will do all the heavy lifting work for you with great accuracy and speed! Another tip is to google up the Bosch videos and app notes rather than the hobby sites. They make it far easier to learn the chip and have a lot of libraries and instructions.

The product arrived incredibly fast—faster than I even expected! While it might be a bit pricey, it’s definitely worth the investment if you want your project to achieve excellent balance and functionality. However, a word of caution: do not purchase this unless you already own a soldering kit. This item does not come pre-soldered, so you’ll need to be prepared for some hands-on work. As a heads-up, I haven’t finished the soldering process myself yet, so I can’t fully confirm how well it functions. That said, it seems very promising so far, and I’m optimistic about its potential. Overall, just make sure you’re equipped and ready for the task, and this product could be a fantastic addition to your project.

One of the best sensors I've come across. If you need position or orientation this is an excellent sensor for that. It's pricey but well worth it given the plug and play nature of this unit for getting the absolution orientation. We used it to stabilize a custom built drone. Building your own sensor from an accelerometer, gyro, and compass with signal processing and filtering would take a lot of effort to get right.

I had tried other 9D0F chips that just output the raw data of all the devices and that required running a Madgwick/Mahoney or similar fusion filter and I couldn't get them to provide stable heading, pitch, roll readings. I was up against a deadline (Halloween) to get it working. Saw this chip and glad I did. This chip already does all that and it is easy to calibrate by just holding it in various positions. Worked great and provides accurate stable readings at up to 100Hz rate.. Now if only my soldering skills were as good as this chip.

This module is the quality I expect from Adafruit and well done. The Arduino IDE library that supports this module is also very well done, easy to use, and made integration of this module into my project pretty painless.

This is an expensive IMU, there is no getting around that. Once it's set up though and you get your initial calibrations it'll correct itself fairly quickly. One of the only IMU's around that will give you absolute heading, especially with such a small amount of required code. I ended up writing my own Arduino library for this that worked really well. In the end I went with a different processor for my project. Regardless of that, I'd absolutely recommend this IMU even for the price, If you don't want to use the fusion modes though, you should get something else and pay about 1/3 the price.

I'm not great at programming so it was a little confusing to get working but once I got it working it's super acurate

It was fairly easy to set up with the tutorial they have on the Adafruit website and at first it worked great but after a short while the System calibration wouldn't reach 3. All of the sensors (accelerometer, magnetometer, gyroscope) would all be at full calibration but it still wouldn't have full system calibration. I learned that this is a common problem for this sensor so if you are looking to use it for the Euler or Qauterion vectors don't get this sensor. It would be great for just the individual readings from the accelerometer, magnetometer, gyroscope.